hey folks,
FINALLY - today is the day I make this thing go.
I have landed my manual tranny and 3.8 SC engine onto the mounts.
Everything is laid out and I am about to start bolting the tin back up.
I took this apart toooo long ago and I cannont remember where a particular brackect goes.
No camera here I will attempt to desribe:
1/4 inch plate metal - factory black
aprox 4X6 inch - about the size of your hand
almost traingular shaped - two open holes(nonthreaded) in the top that are spaced- one inch and a half apart.
The base also has to open holes 3 1/2 inch apart
The wide base- between the two wider holes has a perfect half moon arching up between the holes.
I havent imagined a spot for this yet.
PLEASE ask questions or link photo's
I loathe to bolt anything up whilst ignoring this un-ID'd piece.
I gotta keep surfing till I find this brackect !!
FINALLY - today is the day I make this thing go.
I have landed my manual tranny and 3.8 SC engine onto the mounts.
Everything is laid out and I am about to start bolting the tin back up.
I took this apart toooo long ago and I cannont remember where a particular brackect goes.
No camera here I will attempt to desribe:
1/4 inch plate metal - factory black
aprox 4X6 inch - about the size of your hand
almost traingular shaped - two open holes(nonthreaded) in the top that are spaced- one inch and a half apart.
The base also has to open holes 3 1/2 inch apart
The wide base- between the two wider holes has a perfect half moon arching up between the holes.
I havent imagined a spot for this yet.
PLEASE ask questions or link photo's
I loathe to bolt anything up whilst ignoring this un-ID'd piece.
I gotta keep surfing till I find this brackect !!