PDA

View Full Version : High revs and dies after water pump install



Adv25zero
08-22-2013, 02:40 AM
Just put in a new water pump and gasket. Went to start my 95 sc and it fires up to about 2500 then dies immediately. If I give it has it does the same thing revs up and will die instantly unless I hit the gas. It won't stay at any rpm just up and then down. Baffled ????? Any help is appreciated. Thanks

S_Mazza
08-22-2013, 02:10 PM
Did you remove any of the intake plumbing? Check for things like an unplugged MAF, vacuum leak, things like that.

If none of that was touched, I would say check your wires in the area of the water pump. The crank sensor wires run near there. Maybe something is wet?