fmic

elanoresc

Registered User
so I have been considering upgrading to a fmic ? is I need it done before shootout and in a weekend as my bird is my summer cruiser so no insurance on the truck as of now how possible is this it will be same side in/out thanks for any suggestions or comments
 
so I have been considering upgrading to a fmic ? is I need it done before shootout and in a weekend as my bird is my summer cruiser so no insurance on the truck as of now how possible is this it will be same side in/out thanks for any suggestions or comments

http://www.ebay.com/itm/330369182257?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2649

1 70 degree bend that will connect in place of the stock upper ic pipe, 2 90 degree L bends, 1 straight section, 1 180 degree u bends that need extended 2 inches in the middle of the u and then a tight radius cast 90 degree elbow and either cut off or fill in the gaps on the loper ic tube and connect the cast elbow to it with a 2.75-3.5 coupler.

That's my setup
 
so I have been considering upgrading to a fmic ? is I need it done before shootout and in a weekend as my bird is my summer cruiser so no insurance on the truck as of now how possible is this it will be same side in/out thanks for any suggestions or comments

This was my last fmic set up. This i/c was pretty large for a same side outlet version. You could get a smaller one that wouldn't require as much mods as I did. Yes, you could do it in a weekend but I think that's pushing the envelope, there's always problems that arise.

http://www.sccoa.com/forums/showthread.php?t=128657&highlight=fmic
 
Last edited:
Back
Top