PDA

View Full Version : Where is best place to mount QH cable connector?



HwyStar
10-19-2013, 03:24 PM
I think this question has been asked before, but couldnt find it. Im thinking next to the floor heater register on the passenger side. Then, it would be out of the way if connected while driving. Wished that was the case with the OBD2 connector for newer cars.....

Mike8675309
10-19-2013, 03:39 PM
I didn't mount mine. I stored it in the glove box, and then when doing tuning or data logging I let the cable fall behind the glove box and dash and hooked a USB cable up to it there.

Jacob_Royer
10-19-2013, 08:16 PM
I ran mine out the ashtray same with the wideband serial port. I can just open the ashtray and pull cables out. Works great if you don't smoke lol

HwyStar
10-19-2013, 09:18 PM
Ha, pretty good idea. Swapped computers around at the house so I have my laptop free. Hassling with the software install right now...

nickleman60
10-19-2013, 09:43 PM
I mounted mine below the left side of the glove box along with the wideband jack, easy to access and out of the way.

mywhite89
10-19-2013, 09:48 PM
I mounted mine facing down by the left side of the glovebox using a factory screw that holds the glovebox. I seen a solid 15 rwhp when I was done and it just seemed to idle better as well.

Chris

S_Mazza
10-19-2013, 11:24 PM
I just ran mine into the glovebox. It's a bit of a squeeze, but I can just shut the glovebox with the cable running out the gap between the glovebox and the dash. The coil takes up a bit of space in the glovebox, but not too much.

HwyStar
10-20-2013, 12:12 AM
When I sent off for registration, I also checked Innovate for additional log. Im assuming they meant to log data from the Innovate wide band. Right? Just set it up to a USB port and BE should see it, right? Also, for as little as it was for the bundle, I also got the EEC Analyzer.

nickleman60
10-20-2013, 08:07 AM
On the QH screen go to the hardware tab at the top, on that screen you'll see the Innovate tab, enable it. Then as long as you have the correct cable and port you'll see it on the dashboard screen when running a log. Download and use SCT Livelink to look at your logs.

HwyStar
10-20-2013, 12:28 PM
SCT Livelink do the same thing as EEC Analyzer? SCT easier to use?

Jacob_Royer
10-20-2013, 12:47 PM
Be 2012 will replay the logs you don't even need live link anymore.

Mike8675309
10-20-2013, 07:18 PM
EEC Analyzer is a tool that can parse the logs and calculate various information including calculations to check if you have correct injectors settings, a MAF fitting tool to take your non perfect curve maf table and apply a curve to it averaging values to clean it up as well as add or reduce points.

Plus a bunch of other highly and frustratingly undocumented stuff.