ARP main studs

quatrini

Registered User
Hello all, i have a set of ARP pinto head studs for use as sc main studs, but i was told to use these i need to have my main bores line honed, because you are supposed to torque these much tighter than factory bolts. Is this true? Has anyone used these? and if so what torque spec did you follow? Factory tq? Or what?
Should i use them or just sell them and stick with factory?
 
If you don't use the torque specs that came with the studs and line hone accordingly, then you might as well use the stock bolts.
 
Back
Top