I purchased a Ripper Shifter from another purchaser, never installed but it doesn't have any directions. I know it's fairly simple but a couple of questions. I took the console off and I assume you cut away a section of the factory rubber boot around the existing shifter to get at the bolts. Istall the shifter with supplied rubber boot,there is also a sort of stapled poly strap the same diameter as the lower portion of the boot,is this used or was it just to protect the boot from deforming or something? This is what I assume but just wanted to check as I don't want to take it apart again. I didn't get this with the original box so I'm not sure. I have the little bag with the boot spring clamp and 4 hex head bolts and washers plus the 2 allen key bolts for the shift lever. So I think it is complete.
Thanks in advance
Tom
Thanks in advance
Tom