Custom gauge cluster

Tony8470

Registered User
For each gauge there are 3 pins, B, G, and S. Would it be accurate to say that:

B - Battery
G - Ground
S - Signal

If that's the case, then that will save me some wiring for + & -
 

Attachments

  • image.jpg
    image.jpg
    307.9 KB · Views: 115
  • image.jpg
    image.jpg
    323.9 KB · Views: 115
that is correct. i actually took the gauges out of the cups and put them in the cluster with very little modification.100_1130.jpg
 
Jimmy

I saw your post when I was doing some research. They look good! I wasn't sure that the full sweep gauges would still be viewable through the window, so I just cut it all apart.

What I really want to do is just use the signal for the fuel level.
 
you're right about the view being limited. now that i've seen what you've done, i'm thinking of trying the same thing. I will try painting the bezels black. the b terminal is not on the dimmer, the lighting circuit is seperate.
 
I've been thinking of doing the outer diameter of the bezels black. Maybe just with black sharpie. I want to try just one, but I'm worried it will soak in and won't come out.

They appear to bulge out a little too much being silver.
 
Back
Top