View Full Version : Meth Inj Filter ?

08-11-2014, 07:00 PM
I pulled my meth injection nozzles today to see what size I had, and found them with some crap on them, as well as rust on the screens. Has anybody used one of the inline filters ?

I was looking at one of these.

Also, has anybody else experienced rust on the nozzles befor? I was wondering if it is normal something caused by the washer fluid or if it is from sitting for a few months at a time inbetween drives.

08-11-2014, 08:05 PM
The stock windshield washer line filter should work well, I'd think. If you can find a used one, they are trivial to clean out and re-use.

It is located on the hose from the washer tank, along the heat shield next to the driver's side exhaust on an early SC.

I think you can pick up a new one at most auto parts stores as well.

08-11-2014, 08:27 PM
I dont use my washer fluid res. i use the tank it comes with.

08-11-2014, 08:33 PM
My suggestion was tank agnostic :)

08-11-2014, 09:21 PM
I can't say that I've seen any rust on the nozzle screens, though I was under the impression they were stainless (the Snow Performance ones at least). I've swapped/added nozzles a few times over the past few years, but I haven't seen anything that caused me to consider adding a filter.

08-11-2014, 09:48 PM
I saw rust on some of mine but it wasn't from the screen. It was from one of the parts of the fitting the screen was with. If you are getting junk in the filters it's coming from somewhere.

Mike Puckett
08-17-2014, 05:18 PM
Running mine yesterday, I found the hose fittings at the pump and solenoid leaking and the engine was stuttering a bit at WOT at the 1/8 mile mark. I'm wondering if mine is plugged up, too. I'll stop using it until I can pull the nozzle and check it.

08-17-2014, 06:45 PM
There are additive's for nitro that may help.


08-17-2014, 07:17 PM