View Full Version : black door molding

08-20-2014, 12:20 AM
Looking to replace a couple pieces or maybe the whole trim set.

anyone use this product?


08-20-2014, 08:24 AM
I dont see anything that is even close to what is on the tbird. It is so tough to get parts. The body moildings on tbirds are 1-5/16 wide i believe, with bullet ends. A toyota moulding will work. I dont know what model yet, im not ready to put mine on yet.

08-20-2014, 11:32 AM
Why replace? I just painted mine using the Duplicolor Vinyl paint and they look better than new... I just dont know how they are going to hold up...

08-20-2014, 12:29 PM
Mine have some scars. I dont know if they should have the same finish as the rest of tbe car or if they should match rest of the trim. Any idea?

08-20-2014, 12:53 PM
I have a few sets of factory moldings, both early and late model.
Some good paint, some not. If you need factory side moldings PM me.

08-20-2014, 07:17 PM
The reason I need to replace a pice is because I took it off near the rear fender to fix some rust. When I went to try and put it back on it wasn't straight any more and it looked bad. I'm just hoping I can find something that's similar and replace it all. If not I guess I'm just gonna get rid of it all but I prefer the look with the molding. My car is a 93 and the trim on mine when I measured was an inch in hight.

08-20-2014, 09:17 PM
My car is a 94. Must be a width difference from early to late model. 100 bucks seems to be about the normal price for new. I need to get mine I guess so I will have it.