FRANCOIS DUVAL
Registered User
Hello, I am new to this fórum. I already have browsed trough the fórums searching for a problem similar to mine but no luck so far. So here goes.
I replaced the head gaskets on a 93 SC. The problem is I cannot get it running unless I unhook the CAM sensor. Unhooked, it starts (after 3, 4 tries) and runs fine. But the minute I hook the sensor no start at all. Did the KOEO test and no codes found and after KOER I get a 214 code (of course the sensor is disconnected).
What I have done so far.
-Replaced CAM sensor
-Replaced DIS module
-Replaced Ignition harness (DIS, sensors, coil)
-Replaced PCM
-Replaced PCM to engine harness
-Replaced CRANK sensor
-Replaced coil.
-Replaced spark plugs
_Did a compression test, test results OK
I have used the parts off the working cars (I have two other running vehicles), I bought new CAM sensor and DIS module with exact same results. I ran out of ideas, any thoughts ?
Thank you in advance for the help.
Regards
Any ideas ?
I replaced the head gaskets on a 93 SC. The problem is I cannot get it running unless I unhook the CAM sensor. Unhooked, it starts (after 3, 4 tries) and runs fine. But the minute I hook the sensor no start at all. Did the KOEO test and no codes found and after KOER I get a 214 code (of course the sensor is disconnected).
What I have done so far.
-Replaced CAM sensor
-Replaced DIS module
-Replaced Ignition harness (DIS, sensors, coil)
-Replaced PCM
-Replaced PCM to engine harness
-Replaced CRANK sensor
-Replaced coil.
-Replaced spark plugs
_Did a compression test, test results OK
I have used the parts off the working cars (I have two other running vehicles), I bought new CAM sensor and DIS module with exact same results. I ran out of ideas, any thoughts ?
Thank you in advance for the help.
Regards
Any ideas ?