IMPORTDESTROYER
Registered User
Well, I had my engine rebuilt last year, and to the best of my knowledge, everything was fine and dandy. Much to my surprise, about 150kms later, the *%^#$' pulley, flies of the crank, and much to my surprise, there were only 3 bolts holding it on ; (. After they repair it, about 6 months later, it happens again, today, in the snow, on the highway. Now I'm livid. Upon inspection, i find all for bolts are sheered, and stuck in the block. This is why I hate those kiniving theves that call themselves professionals. Any suggestions on how I can remove these bolts??
Thanx
Luke
Thanx
Luke