PDA

View Full Version : Asp UD pulley install?



shocar4
12-26-2014, 10:35 PM
A few questions.

1. What all do I have to remove from stock crank pulley to remove it? Just 4 bolts? Or does main crank bolt need to come out too.

2. I have a small amount of end play in water pump shaft....but no issues with noise or cooling....should I replace or just wait for now....

Any other thoughts while I'm in there?

SCarSC
12-27-2014, 11:05 AM
S this should be in technical right? The crank just needs the 4 bolts like you said, might be a bit rusted to the balancer.

I went ahead and did the water pump when I did my bhj balancer as a precaution. Well I loosened the studs that connect to the block and apparently broke the timing cover gasket...so that was a lot of extra work for something that wasn't broken...I say leave it alone or risk having to pull the timing cover right after the install.

shocar4
12-27-2014, 07:10 PM
Ok got them on.....gotta grab a shorter belt then I'll be all set!

KMT
12-27-2014, 07:27 PM
A few questions.

I have a small amount of end play in water pump shaft....but no issues with noise or cooling....should I replace or just wait for now....

Any sign of leak at the weep hole? Any idea how many miles on it?