Mustang Throttle Body

TBirdJKC

Registered User
I just got my hands on an FRPP 65mm throttle body for my 5.0 bird. It has the SN-95 mustang linkage setup. I remember someone on here did a nice write up with pictures on how to modify the linkage plate using the factory one, so the thunderbird cable will snap on. Searched all morning but couldn't find anything. :confused: Can someone post a link or walk me through it please?
 
I did it on a Mustang 75mm throttle body a few years ago. I used a sharp file to cut away the flattened part of the shaft so that the mustang linkage could be removed. Same for the thunderbird linkage. After removing the shaft from the new throttle body, I used a die to thread the end of the shaft to a matching nut. The linkage was then attached using that nut and a disc lock washer.
 
Back
Top