Where does the Yellow 'Injector Signal' go for the N2MB WOT Box?

HwyStar

Registered User
It says injector signal. That means nothing to me. Do they mean the injector power? Red wire to the injectors? Ground is switched, so the only one wire I can think of is injector power. Just want to be sure...
 


That's pretty much it. There aren't instructions specific to our car. Everything else is easy enough.
 
According to table two farther down the document you have to tap into the crank position sensor.

"Ford Mustang Cobra 4.6SC 94‐04 Crank ~~~ Sensor DARK BLUE 2 DARK BLUE 21
Ford Mustang and GT 05‐06 Crank ~~~ Sensor BLACK/PINK 1 BLACK/PINK 47E
Ford Mustang, GT, GT500 07‐09 Crank ~~~ Sensor BLACK/PINK 1 BLACK/PINK 47E"

I think Table 2 is on page 5 of your instructions. If you're like me you get knee deep into the install before you read anything... :D
 
I didn't think the guys at n2mb would return my email as fast as they did. But, turns out that wire goes to the switched side of any injector as a rpm reference. I've never seen rpm reference done this way. New to me, but it's what they wanted.
 
Back
Top