19"x8" Wheel Offset

Stumbled across some 19"x8" wheels with 45mm offset, figured they might work but wanted some wheel expert advice.

I'm getting bored with rocking the stock wheels although it adds to the sleeper look.

+45 on 8" wheels is going to be "tucked under" a bit. +38 to +40 is a better choice for that width on an MN-12. If the wheel you like is only available in that spec, maybe consider running some thin spacers to push them out. And then if the stud hole diameter of the wheel is large enough, you can use this type of nut to get back some thread engagement:






cheers
Ed

I run a 19 x 8.5 front 19 x 9.5 rear I will check to see what the back space is on the spare I have in the basement but my fronts are 8.5 like I said.

Holy crap you're alive! Still turbo?

neverfastenough said:

Holy crap you're alive! Still turbo?

Click to expand...

Still alive, still turbo boostin.....car was actually my daily driver for about 3 months because a piece of crap Subaru i bought spun a rod bearing.

Go figure a 90's 500hp Ford it's more reliable than an 09 Subaru.

I've never known a person with a properly running Subaru.