View Full Version : Rear glass molding

08-16-2015, 03:25 PM
Hello I need to reseal my rear glass on my 89 S/C
Question how do I go about removing the side and top moldings.

08-16-2015, 08:36 PM
Carefully with a flathead?

08-16-2015, 10:35 PM
The side moulding AKA-drip rail has a 10 mm nut that is accessed fro the interior. Back seat above and to the side a small round plug that pops out. The nut is in the hole. once that is out start prying up on the molding. It should pop out of the clips that hold it. It is attached to the front Drip rail by a piece that slides into both parts. Kinda like a knife into a sheath. the top moulding will pop strait up' Best to have the proper tools but a screw driver will work. slow and easy is the key. The bottom moulding has small plastic clips that must be pushed off the (nail heads) that hold the piece in place. I made a tool to remove them.