Falcon20x
Registered User
Awhile back I had what I believe was a engine overheat. I noticed the temperature gage dropping down to almost nothing, the coolant expansion tank was full with a lot of air bulbs coming up. I was expecting the water pump to have failed so I started to tear down the engine and found out that the themsotat fail safe had worked as adversidsed but instead of a bad water pump it was a sheared off head stud that caused the problem.
The fan always worked as it should until that day. Now regardless of the temperature of the engine ithe fan runs all the time. Is there a reset or something that I' m suppose to do after a overheat.
I rebuild the engine and it should be ready to go in a week or so. I really do not want to have to do this again
The fan always worked as it should until that day. Now regardless of the temperature of the engine ithe fan runs all the time. Is there a reset or something that I' m suppose to do after a overheat.
I rebuild the engine and it should be ready to go in a week or so. I really do not want to have to do this again