PDA

View Full Version : 10% steel OD pulley



JeffTBird93
01-30-2016, 10:36 AM
Bought this a while back, but got a heck of a deal on an aluminum one instead on craigslist locally. It will need a quick coat of paint as it's been stripped down to bare metal (can snap a pic if really needed). Also has the nut on the front to help with tightening the SC nut.

$50 shipped to you.

BigTbirdcoupe
02-14-2016, 06:41 PM
Bought this a while back, but got a heck of a deal on an aluminum one instead on craigslist locally. It will need a quick coat of paint as it's been stripped down to bare metal (can snap a pic if really needed). Also has the nut on the front to help with tightening the SC nut.

$50 shipped to you.

Got a pic? I will have to go with a smaller belt with this pulley right?

JeffTBird93
02-14-2016, 07:04 PM
Yep...

http://i20.photobucket.com/albums/b239/281Thunder/IMAG0874_zpsfdywtgnr.jpg (http://s20.photobucket.com/user/281Thunder/media/IMAG0874_zpsfdywtgnr.jpg.html)

I've read you can use the stock belt. I've got a stock belt on mine, but the upgraded tensioner springs are highly recommended (mine isn't running yet, but going off of what I've read).

BigTbirdcoupe
02-14-2016, 07:18 PM
Ok that's what I figured and have been seeing around when looking for pulley upgrades is the belt. My belt is tight as a mofo and is a ~~~~ to install (it's a week old) stock belt and pulley. I was asking because the smaller belt is the expensive part I'll do me some looking for what I can get one for with a belt 1st. Where are u located if I'm in the hampton roads area of Va

KMT
02-14-2016, 07:35 PM
Don't forget that there are alternate size idler pulleys that might help when trying to fit different sc pulleys and belts.

JeffTBird93
02-14-2016, 09:48 PM
I'm in the eastern panhandle of WV...about an hour west of DC.