While waiting for new bolt & bhj I removed broken bolt with a drill bit & an easy out & broken off snout with a drill bit & two 3 1/2 drywall screws a couple of washers & a steering wheel puller. Both pretty easily I might add. I ended up not balancing stock pulleys with bhj. Thought I was going to finally get my car out of this f*cking parking lot. But now I'm not getting any spark. Crank sensor looks OK. Minus one nut for the plastic cover is missing. Not sure how to check it properly tho. I disconnected battery hoping it might reset or something. Pulled #1 plugs wire & checked spark there with no belts or pulleys on car. I am trying be able to drive my car out before it gets towed & costs me even more.. Its been stuck here since easter! Any timely advise, or a point in the right direction would be greatly appreciated