PDA

View Full Version : 8.8 rear diff.



nanatothesixth
10-15-2016, 02:57 PM
looking for a 8.8 TL 31 spline iron or aluminum with 355, 327 gear in good working condition!

SC79
10-16-2016, 07:32 AM
Haveone, PM sent

nanatothesixth
10-16-2016, 09:14 PM
still looking!

RadBird
11-15-2016, 10:23 PM
A 2002 Explorer 31 spline limited slip will fit your housing, get both half shafts from the Explorer you will need the inner stubs. To make it work the inner stub shafts need to be turned down where the seal is. The Explorer stub shaft is bigger where the seal is, have the shaft turned down the same diameter all the way to the bearing housing. You will also need to have .250" taken off the ends of the shafts so they seat properly in the housing. After all the machine work is done but the Explorer stub shafts on your axles pack with new grease, put new clamps on the rubber boots and you are done.