PDA

View Full Version : Tailight questions.



Creighton
04-16-2017, 10:24 PM
Starting on a bit of a mod. Anyone know if possible to bake the assembly at low temp/short duration to get the back housing off? Saw something on doing this with headlights...

Would like a six bulb per side electronic sequence assembly. Same idea as the 1965 Bird mechinical. Have yet to locate one.

Blue tape was for aligning a 3 light affair. When power applied to bottom bar, think 6 will work better with the outside going to the factory turnsignal. As always suggestions welcome.

Thanks!
Creighton

KMT
04-16-2017, 10:55 PM
Seen this 2006 TCCOA thread?

http://forums.tccoa.com/15-exterior/82301-sequential-turn-signal-tail-lights.html

Creighton
04-17-2017, 12:21 AM
Had not. Thought I had searched every which way from Sunday.
Thanks Ken !!

Will see if the Redneck folks are still in biz Mon. Could be built for far less but the time to sort it all out is more than asking price. Surprised the package doesn't show up on search.

Test unit is glued on the corners. May not go back together, but I will get it apart :-).
Creighton

KMT
04-17-2017, 12:35 AM
I'm sure you have a plastic welder in your kit ;)

Creighton
04-17-2017, 01:59 AM
Had one, worthless for this app. Better half uses it for crafting, with success :-).
Creighton