PDA

View Full Version : Identify rear axle ratio



RS2600
06-14-2017, 04:31 AM
Hi all,
Just bought myself a 95 SC with a warmed up engine, dyno says 330 rwhp. Don't have the specs yet but it's moving along quite well.
Looking at the door jamb data plate AX=9 and TR=LKKJJ. Been trying to decode but no luck. Any help appreciated. By the way car is
a Canadian car with km/h speedo.
Thanks,
Matt
Sweden

Silver95bird
06-14-2017, 07:19 AM
http://www.tccoa.com/articles/gears/gears.html

The chart of axle codes doesn't list a code "9". Are you sure that's it?

The L indicates a 4R70W transmission, the KK and JJ are the front and rear spring codes respectively.

Tom

BLOWN38
06-14-2017, 10:14 AM
If it is stock it is probably an open 3.31 for the auto cars. Thats what mine was.

And 3.31 isn't listed in the Tccoa article so probably a good chance thats it.

And the other 95 auto I have here has the code "9". But Id have to lift it to see if the stock tag is on the housing to see what that says.

There should be a tag on the diff housing that will have the ratio on it. Would be something like 3 31 for an open 3.31 or 2L73 for a locker 2.73.

Silver95bird
06-14-2017, 12:27 PM
I suspected that was possible, I remember A-Train posting about those cars years ago. Never was under one in person to see it though.

RS2600
06-14-2017, 02:33 PM
I'll get under the car later and check.
Thanks

nickleman60
06-14-2017, 02:49 PM
If all else fails jack the car up and spin the rear tire 1 revolution and count how many times the drive shaft turns............:p