PDA

View Full Version : Alignment problems



Csirny
08-31-2017, 07:19 PM
I recently had my alignment done after replacing my lower control arms do to a bad ball joints. My car just broke luckily right by a stop sign. I'm trying to determine if it was my mistake or the shop I went to. What happened is the nut that holds the bar that goes from the frame to the control arm came off. Is it likely that I didn't tighten it up? Or is this something that would have been loosened to adjust the caster?

CougarXR/7
08-31-2017, 07:24 PM
I Road Course my car.......had one back off ......but ........track time puts a lot of stress on the car

Csirny
08-31-2017, 10:00 PM
Thanks. I kinda figured I didn't tighten it good enough. The adjustment appears to be done on the frame side and i had the cap nut come off.