PDA

View Full Version : PN for replacement plastic fasteners for intercooler shroud (pix inside)



CaifanSC
09-05-2017, 10:06 PM
I'm missing some of these in the chameleon. I was able to source what I think is the closest thing to the original. The only difference is that the original is slightly shorter than this piece. I don't envision the length should be an issue, but I should confirm in a week or two when I replace the rad.


New on the left, used on the right.

https://i.imgur.com/JAarsPc.jpg?1

https://i.imgur.com/dIbYrml.jpg?1

https://i.imgur.com/h2ESGJG.jpg?1

https://i.imgur.com/dposB8z.jpg?1

KMT
09-05-2017, 10:25 PM
Might be a risk of not sealing w/the longer stubs....