Can someone measure somethign for me, that sounds bad doesn't it!

[V6Sprout]

I just got a set of "SC" letters from the front bumper of a Supercoupe, I am gonna put them on a MUSTANG GT bumper and swap the GT for the SC so I get MUSTANG SC. Anyways the front bumper has larger letters for the SC then the back, they are the same height as my mustang letters but they are about 1 1/2 ties as weide, they will look OK but I was wondering if someone could measure the SC letters on the back, let me know ow tall and how wide each letter in SC are? Thanks guys!

[Bill McNeil]

Around 8 inches.

OH, the letters, sorry.....I haven't measured lately.:rolleyes:

[V6Sprout]

bill, small guy, buddy, friend, hahahahahahahaha :)

Yeah I mean the bumper, oh and BTW 10 inches over here, I hope at least :)

[V6Sprout]

has anyone had a chance to measure the SC letters for me yet? :) I need the length and width of the S and the C

thanks!

[AsScLoWn]

28X58mms in the recessed part, with a 2mm border(the angled part that meets up with the existing contour of the bumper)around each letter.
yea I was bored:D

[V6Sprout]

cool, thanks bro, now time to go measuer the letters on my mustang bumper, nah its too damn cold out right now, tomorrow I'll measure mine :)

BTW, that looks like the measurements for the front SC the width is about double the height, aren't the rear SC letters smaller, not a wide? You measured the rear SC letters right? Just making sure. :)

Thanks agian!

[AsScLoWn]

yea, these are for rear letters, front are bigger