jacobhobbs08
Registered User
Hello all. I bought a SC a few months ago that i had to put the engine back into. I followed all the steps in the service manual and the car is together and will crank when the key is turned.
My issue is that I have zero fuel pressure and I can't hear the pump prime. I show 0 psi at the fuel rail with a pressure gauge.
Since its a 94 SC, I have tried tapping the relays in the IRCM and still no fuel pump. I have checked the inertia/shutoff switch in the drivers side trunk and that is fine.
The only thing I hear if i cycle the key to Run and then back off is a clicking noise from the passenger side rear.
I'm kind of at a loss at this point. Does anyone have any insights?
My issue is that I have zero fuel pressure and I can't hear the pump prime. I show 0 psi at the fuel rail with a pressure gauge.
Since its a 94 SC, I have tried tapping the relays in the IRCM and still no fuel pump. I have checked the inertia/shutoff switch in the drivers side trunk and that is fine.
The only thing I hear if i cycle the key to Run and then back off is a clicking noise from the passenger side rear.
I'm kind of at a loss at this point. Does anyone have any insights?