PDA

View Full Version : got a problem



jacsxr7
11-29-2002, 06:54 PM
changed some sensors. disconnected the battery. put sensors on connected battery. turned on car but then turns off. unless i give it gas. but then when i let go of the gas it dies out. i run codes but nothing comes out. codes are clear. any help please

thanks


Jose

Thrty5thSC
11-29-2002, 07:16 PM
have you also checked key on engine runnig test?

38SCPROJECT
11-30-2002, 02:45 AM
Check the IAC valve.... they stick and go bad sometimes.... Check the red wire going to it to see if it has 12V key on engine off. If the iac is ok you may want to clean it why you have it appart.
Try tapping on the mass air flow also... this is a wiggle test - ford name - for testing it... if it stumbles or dies or hickups or anything swap it out - maf do go bad, but not very often. Check the TPS for voltage should be .50 ct (I think) and over 4.50 WOT.

Good luck...