Ok, the torque sequence is:
Third Top Bolt
Third Bottom Bolt
Second Bottom Bolt
Second Bottom Bolt
Last Top Bolt
Last Bottom
First Top Bolt
First Bottom Bolt
Torque Spec:
Torque in 4 steps
1) 50Nm/37 Ft-Lb
2) 60Nm/45 Ft-Lb
3) 70Nm/52 Ft-Lb
4) 80Nm/59 Ft-Lb
Then Back off 2-3 turns
Tighten to 48-55 Ft-Lb
Rotate an Additional 90-110 Degrees (I hate torque angle, what I did was use some touch up paint/nail polish and mark the head of the bolt and the cylinder head about 95-100 degrees, and turn til the marks line up).
It's kind of annoying but there it is straight from a 91 Ford service manual.