Here's the story..
IYou start driving the car and it's all good.. about 10 miles or less into the drive you hear a `knocking' type noise from behind you.. futher down the road it starts gettign worse and you can almost start feeling it when it gets really loud...
BUT..
The Noise seems only to be there well cruising and under light Accelleration.. Under Medium and hard it's not there.. under decelleration you hear it once in a while.. under braking, it's not there...
ALMOST sounds like a halfshaft is about to go.. (Driven my share of FWD with bad halfshafts ) and drivers has some play left-right (movement the length of the shaft) don't know EXACTLY where the movement is.. just know it's moving.. also seems once inawhile to have movement up and down.. (once again not shure exactly where.. all this was done in a underground parking lot, not light by feel only ) but the passenger side feels nice and tight, no movement in any diection..
Also The diff is rebuilt (? looked it when i put it in), New U-joints and a balanced driveshaft, and the companion flange bolts are tight.. and wheel breasing seem good.. (never spun them, but no movement)
Did i miss any info??? if anyone can help please do so
Also can you use a 5spd right halfshaft on the left side??
Thanks in advance..
IYou start driving the car and it's all good.. about 10 miles or less into the drive you hear a `knocking' type noise from behind you.. futher down the road it starts gettign worse and you can almost start feeling it when it gets really loud...
BUT..
The Noise seems only to be there well cruising and under light Accelleration.. Under Medium and hard it's not there.. under decelleration you hear it once in a while.. under braking, it's not there...
ALMOST sounds like a halfshaft is about to go.. (Driven my share of FWD with bad halfshafts ) and drivers has some play left-right (movement the length of the shaft) don't know EXACTLY where the movement is.. just know it's moving.. also seems once inawhile to have movement up and down.. (once again not shure exactly where.. all this was done in a underground parking lot, not light by feel only ) but the passenger side feels nice and tight, no movement in any diection..
Also The diff is rebuilt (? looked it when i put it in), New U-joints and a balanced driveshaft, and the companion flange bolts are tight.. and wheel breasing seem good.. (never spun them, but no movement)
Did i miss any info??? if anyone can help please do so
Also can you use a 5spd right halfshaft on the left side??
Thanks in advance..