Need help getting off Supercharger case...

935spd

Registered User
I'm rebuilding my supercharger and need some help on trying to get my case off. I took all the bolts out of the front and got the snout off, but I can't get the rotors out of the case. I tried using a screwdriver and hammer to seperate the case, but it just keeps messing up the case and won't budge free. I was thinking about trying to hit the rear bearings to pop the rotors out since I will be putting in new bearings. Anyone know what to do?

Thanks,
Nick
 
Here's what worked for me...
Lay the charger on the bench, with the top side up.
Using the wooden end of a ball peen hammer (small), insert it into the top and butt it up against the front plate, making sure you don't contact the rotors or put stress on them.
Use another hammer and tap on the metal end of the hammer. This area is sealed with silicone, so you will have to tap on the hammer to push it apart and break the silicone free. It got mine apart no problems, without damaging anything.
Good luck!
 
I just hold it up-side down and hit the break with a 2X4, tapping around the case. they should just fall out once you break the seal.

Jeff
 
Back
Top