siebersblack89SC
Registered User
How safe would it be to run a 10% od pulley and a Ported blower
on a '95 5spd with 90,000 kms with 2.5" down tubes into high flow cat's into a stainless Magnaflow duel in single out into 3" center section into 2.5" rear into two two chamber Flowmasters.
It also has a 76mm MAF a MAC cai,75mm t-body on a stock bottom end with stock head gaskets.I know im missing stuff but thats perty much the just of it.
Thanks.
on a '95 5spd with 90,000 kms with 2.5" down tubes into high flow cat's into a stainless Magnaflow duel in single out into 3" center section into 2.5" rear into two two chamber Flowmasters.
It also has a 76mm MAF a MAC cai,75mm t-body on a stock bottom end with stock head gaskets.I know im missing stuff but thats perty much the just of it.
Thanks.