New 190lph /30lb injectors /kirban AFPR. Got a question.

tbirdboy

Registered User
Once all is installed and with KOEO what should my pressure be at the rail? Also KOER what is my pressure at idle. I hope to get mine on a dyno soon to have my A/F ratio taken and fine tuned with hopefully several more horses than when I go in. Cost is a factor right now(no money) and I need to keep from blowing black smoke which im suspecting will be the case when the job is done.

THANKS IN ADVANCE!

www.proficientperformance.com
 
Last edited:
You are supposed to set the pressure with the engine running (idle) and the vacuum line off of the regulator and plugged. Stock static pressure is 39-40 psi.

If your running stock injectors, set to stock pressure, your not going to see any extra power. All the fuel from the larger pump that isn't used by the injectors, is just returned to the tank by the regulator.


David
 
Back
Top