Addco front bar owners

James Kanteraki

Registered User
I just got my front Addco 1&1/4 sway bar in the front.

I put it on with the shims under the bolts and with the suspension fully extended -- wheels off ground and the stupid thing is pushing on the hub pulley. So I'm looking at it and wondered what those shims are for. I called up and the "phone jockey" said he didn't know.

So i took them out and now i have acceptable clearance.

Just wondering what other people think about this, or if they have observed this.

Not that I go getting all air borne or anything but that ain't right.

Jim
 
hub

Damper pulley, crankshaft pulley, the big thing on which all belts run. That thing in front of where the crank sensor is attached.

got it?

jim
 
well, check this out boostman23

get the front of your car all the way off the ground both sides, lift where your not putting pressure on the suspension.

see what happens...

check the bar to hub pulley clearance

in the mean time, don't go gettin' air borne.

jim

ps, not that it would matter, but i have the 1 and 1/4 inch bar.
 
Back
Top