i have the motor out of my 90sc and i will change the main and rod bearings the motor is in very good shape other then a rod bearing going bad.
the rods them self are good for std bearings and the mains also i need to check the bores with a mic but i can see the cross hatching or what every it is called in the bores.
i would like change the rings if i dont need to have any machine work done can i just pull the old ones and put new in or do i need to do any thing to the bores
ps there is no ridge on the top of the bore the block is realy in great shape
the rods them self are good for std bearings and the mains also i need to check the bores with a mic but i can see the cross hatching or what every it is called in the bores.
i would like change the rings if i dont need to have any machine work done can i just pull the old ones and put new in or do i need to do any thing to the bores
ps there is no ridge on the top of the bore the block is realy in great shape
Last edited: