my chilton book gives me the rod journel size and the crank main size but not the (CRANK ROD) journel size can some tell me what it should be for a 90 sc thanks
-measure the bore at 3 different points(see if its out of round)
-bolt the rod onto the crankshaft with a bearings and plasti-gauge
-see what the clearance is
-remove only one rod nut, and measure the gap between the mating surface of the rod cap with the loosened nut(should be at least .003"? space)
so if the
-bore is round
-oil clearance is good
-cap crush" is within spec