pulling codes on a 91 sc

95_5speed

Registered User
Pulled the codes useing a jumper wire and the key on engine off.
But don't understand the message I think it hates me.

I got 2 short close together
1 by itself
1 by itself
6 short close together
1 by itself
1 by itself
4 short close together
5 short close together
4 short close together
2 short close together
1 by itself
6 short close together

think I'm back to the start of the codes also have the list from the 35th registry but unsure what codes are.
HELP PLEASE!!!!!!!!!
 
tccoa.com has a list of all of the EEC-IV fault codes. They are also in the Haynes manual. I believe the EEC repeats all codes twice. Keep trying and you'll get the hang of it. There should be a slightly longer pause between individual codes than between different digits within the same code. You can run them as many times as it takes to figure out what it is trying to tell you.
 
Is there any way to clear the codes with out a scanner.

It looks like were gettin a MAP sensor or a TPS sensor code
what do you guys think
 
No you need one of those fancy code readers to clear them. Or, if you fix the fault the light should go off by itself. What is the car doing? Try scanning the codes a few more times until you get the hang of it.
 
The car has a rough idle, when driving anything over 1/2 throttle it cuts out and falls on it's face. exhaust smells rich and blows carbon on the ground it just started out of nowhere:mad:
 
Back
Top