HELP!! I desperatly need a Mark 8 caliper bracket!

phils89sc

Registered User
I went to the salvage yard last weekend and got everything I needed for my 11.5" Mark 8 front brake swap. But, one of my caliper bracket that I bought has a guide pin broken off inside of it and I cannot get it out!! I don't know what is holding this damn think in there, but it is pretty well stuck. I have tried drilling through it, hammering it, etc...

The only other hope I have as far as I can tell is to hope someone on this board hears m plea and has an extra to sell, or some really good advice on how I can get this broken pin out.

Please help!!!

Thanks

Philip Stocker
 
another solution?

If it's like the rear caliper pin sertup perhaps you can drill in from the other side, drive it out with a small pin and then weld, peen (work with a small hammer), or silicone the hole shut.

Good luck
 
Back
Top