Need help with Codes...

Ok I been doing some research and I went to Autozone and had them run diags and I got the following three codes...

113 - ACT/IAT Sensor has intermittent high voltage

212 - Loss of IDM input

214 - CID circuit fault

Now by searching the forums here I found this thread

http://www.sccoa.com/forums/showthread.php?s=&threadid=9235&highlight=IDM

that basically tells me the 212 and 214 codes are saying my cam sensor is bad... Right?

I'm having trouble though figuring out wtf the 113 code is saying.. I know IAT means Intake Air Temperature but is that a sensor or something because I can't find anything relating to that anywhere... Thanks for your help...

air charge temp sensor is located on the intake tube that is next to the master cylander there is a vacuum line right next to it for your boost guage. you can get one at napa for 20 bucks.
joe

And yes, the 212/214 combo is usually the cam sensor.

Dale

in my book #212 is LOSS OF IGNITION DIAGNOSTIC MONITOR (IDM) SIGNAL- SHORT TO GROUND IN SPARK OUTPUT (SPOUT) CIRCUIT. #214 CYLINDER ID (CID) SENSOR - CIRCUIT FAILURE.