poor psi while boosting... : (

SCboost

Registered User
i just noticed that i am only getting teh boost needle to go to the "I" on PSI. im SURE it should go higher than that. i have off mufflers and a large K&N. any ideas. thanks. also could my gauge be bad? i don't hear any leaks...but could the gauge be faulty? any way to test it? thanks again. steve.
 
If you are talking about the "I" in PSI that is typed on the guages that is about 7PSI which is about normal for just around town driveing.

Good Luck
Tim
 
just for the heck of it

whats the needle point to when engine off. mine shows -3.
when its at full boost shows 12lbs with a 10% pully but my sw gauge says 15lbs the factory gauges are not all that acurite if at all some bad some right on check with a good after market gauge.
 
Need to replace...(For the "I" problem)

You need a new booster seat...

It will help out with boosting problems and allow for correct alignment of the psi-pin.
 
Back
Top