dumba$$ needs help...please?!

drak347

Registered User
I accidentally bumped a few needles before I recorded their position while installing my white gauges...will this cause a problem? Any help would be greatly appreciated?

-Dan
 
set the speedo and tach to 0 with the key on, when you fill the gas set the gas gauge to full or to wherever it was last. When the car has fully warmed up place the temp needle to normal operating temp and just set the oil pres. gauge about 3/4 to the right. Always set them with the key on. The boost gauge is set to 0 zero also with the car off. So bolt the gauges back in with the front plastic cover off.


I personally would disconnect the fuel sending unit connector and set the fuel gauge to the left of the red slash
 
Last edited:
Back
Top