oil pres.sending unit

pete buck

Registered User
ok here is a stuid question....where is the oil sending unit located,i believe mine is on the frits because my oil pres.gauge will go from just below the n to the middle of o and will bounce around,plenty of oil every time i check it,and no lifters tapping,engine running smoothly,so i figure its probaly the oil sending unit,but i dont know where its located at.please help.thanks
 
i think if you look in the front of your motor to the right side of the cam sensor -down and back a little you will see a small unit about quarter size round and an inch tall with a single wire on the top
threaded into the block--it easier to get at if you remove the acc belt
its usually a loose wire on the top of it but its cheap to replace
g/l
 
Back
Top