Yo, Skip !

I wish I knew Fred.....
Damn machinists.....Race season around here has these guys really busy! I am SOOOOOOO anxious though.

Just outta curiosity Fred, did you get any flow numbers on these heads?
I was thinking of having them throw 'em up on the bench to see how they do. I also need advice on the whole TB, MAF deal. I am now re-thinking of going with the 85mm TB and a 90MAFS. Any suggestions? I know I probably don't need it, but if I am going to buy a new MAF, why not go for the CORKA?

See ya
 
Not familiar with Corka, but the 90 Lmaf and 85 mm would work great ! Flow is 210 SCFM at .500 lift on the intake side. You have enough cam to support all the air you wanna throw at it.
 
U mmmm, Corka, as in "YUGE", like the Italians of my area would say! LOL!
Anyhow, thanks. Perhaps this week I will have a better feel for how far along my engine is. With my luck they probably still haven't touched it.

PS, wasn't my lift like .530 or .550 or something?
 
Any speculation on the cfms at that lift?

BTW, How is your engine coming along?
 
Back
Top