26 degree atdc mark

creeperxr7

Registered User
were is the 26 degree atdc mark on our balancers. Trying to set timming but my balancer only goes up to 10 degrees. Is the 26 degree mark the groove after 10 degree atdc mark any refrence appreciated.
 
Measure what 16 degrees is with a tape measure with your existing tick marks. Then use a permanent marker and add that to the end of your 10 ATDC mark.

If you have your old balancer, compare with a tape measure how far from TDC is to the 26 ATDC slit is.
 
Back
Top