PDA

View Full Version : Clutch Hydraulic line question



6pak2go
08-23-2003, 08:31 PM
I'm replacing the transmission in my '91 and I'm having a problem getting the hydraulic line off of the slave cylinder. The manual I have sais to press in on the white ring while gently pulling the hydraulic line. It's not working for me at all. Any secrets on getting this biatch out?

Brandon

tbird88
08-23-2003, 11:14 PM
I know, it's aggravating but you have to make sure that little white sleeve is all the way in. Gotta check to see that it's in all the way around too. Use a small flat-blade screwdriver to work all the way around to press/slide the sleeve in, try not to bugger up the sleeve, a little bit of WD40 might help if there's some grit/dirt around the fitting. If ya hold yer mouth just right, next thing ya know the fitting will slip out with no resistance whatsoever.

Keep tryin', it'll come out.

'bird