V6Sprout
Registered User
Since I have the SC motor in my mustang I am using the Mustang wiring harness. It fits but barely reaches around the blower to the drivers side injectors. I was thinking of extending that entire side of the harness about 3-4 inches but I think it woudl just be easier to extend the injector plugs 3-4 inches each since its only 2 wires on each injector plug instead of the 15+ wires on the harness. My question is: Will extending the wires on the injectors have any ill effects on the operation of them? Cause the drivers side injector wires will be longer then the passenger side now. I doubt there will be a problem but thought I woudl get some expert experience before I go and cut and solder them. I am just not sure if it would have any effect on the injector pulse due to being slightly longer then what the factory had it at.
Thanks!
Thanks!