rear end setup

redmonster

Registered User
I just changed the pinion seal on my 8.8 and when I test drove it I heard a terrible noise when I let off the throttle to stop .I only changed the seal and put a new crush sleeve in . I torqued the pinion nut to 150 ft lbs which is what my factory specs say it should be. ( 140 + 8 to 14 when using new sleeve.) Someone told me the pinion depth is now wrong. Anybody know an easy way to get this back to specs and are my specs correct? I got new pinion bearings so if I have to disassemble I can replace at the same time. Thanks in advance for any help.
 
Back
Top