superc0upe
Registered User
Found my brake fluid leak and just about to install a brake pressure switch (the one for the ARC).
I saw from different posts that its fairly easy. I don't want to ask a stupid question but i want to do the job right.
Do i just unscrew the screw thats holding the switch onto the frame, unplug the wire and then unsrew the brake lines?
Is unsrewing the brake line the proper way to remove it from the switch?
Also, i also read that if i can put the brake lines back unto to switch fast enough that I do not have to bleed the brakes?
Thanks in advance for answering a simple question that I couldn't figure out
I saw from different posts that its fairly easy. I don't want to ask a stupid question but i want to do the job right.
Do i just unscrew the screw thats holding the switch onto the frame, unplug the wire and then unsrew the brake lines?
Is unsrewing the brake line the proper way to remove it from the switch?
Also, i also read that if i can put the brake lines back unto to switch fast enough that I do not have to bleed the brakes?
Thanks in advance for answering a simple question that I couldn't figure out