75mm TB

super6turbo4

Registered User
After receiving a BBK 75mm TB for free I ported my inlet plenum to match the new TB. I then put the car on the dyno to see what the difference was. It was down 9HP and 13LBFT. After about an hour of adjusting fuel pressure I ended with the exact same HP and a gain of one LBFT.

I thought this could be some good information for any prospective buyers.
 
Last edited:
Some very good info. I suspected as much since I did not notice any gains when I put mine on.

Some people have reported a couple hp from the 70mm but there may be just too much necking down that occurs from the 75.
 
Tbird 88,
I'm using a 76mm C&L that gained 10RWHP on its own. You can see the rest of my mods on my member's page.
 
Must be time for a Raised top.


Then you really liven it up with the MPII and Inlet plenum.
 
Back
Top