replacement hub rotor problems

HSKR

Registered User
Has anyone esle had any problems with aftermarket rotors fitting on the studs on replacement hubs?? Recently had to replace the drivers side rear hub after the wheel bearing went out. I had upgraded the rotors all around to slotted and cross drilled rotors and they fit fine on the factory hubs, but wouldn't fit right on the new hubs due to one of the lugs being different than the rest. Verified that it wsn't just a bad hub by comparing it to another at the dealer which was the same. The back side of my rotors didn't have as deep of a bevel as the Ford to Reybesto's rotors I compared them to either. 30 minutes with a dremel tool and the rotors worked fine, but was an unexpected delay which took two days due to dealer parts counter not open on Sundays.
 
Back
Top