How do I get the "CHANGE OIL NOW" thing to go out

How do i do it? It has all new fluids and the oil change light is on along with all the other fluid lights? Oh and it is an 89 SC.Thanks Derek

Take a paperclip and insert it in the little hole on that plate.

You have to do it when the engine is off... but the key is on.

The whole display will blink a few times and then reset back to "OK".

After changing oil, the VMM must be manually reset. To do this, look for a button on the left side of the display to press for a few seconds. Some have indented buttons that you must use a paperclip or pen to access.

As for your other lights, are they green or are they yellow indicating low fluids? If they all say low, and you know your fluids are ok, I would suspect the VMM.

Hope that helps..

syphon said:

Take a paperclip and insert it in the little hole on that plate.

You have to do it when the engine is off... but the key is on.

The whole display will blink a few times and then reset back to "OK".

Click to expand...

Yup. But just to add a few details. Key on to run position, within 5 seconds push end of big paper clip in hole and hold until display stops blinking and says OK.